- Description
-
Details
Ideal Calcium Hardness level: minimum 200mg/l (ppm)
Low Calcium Hardness causes corrosive water and etching of surfaces.
Application Instructions
- Before applying this product it should be pre-dissolved in a clean plastic container at a maximum rate of 100g of product to 10 ltrs of cold fresh water. Stir well to ensure the product is fully dissolved. Repeat application to achieve the total dose required – see table below for dose rates. It is recommended that the total treatment is split into three equal applications with a minimum of 8 hours between each.
- After pre-dissolving add the resulting solution to the pool near the inlets with the filtration system in operation.
- Following the application the pool water may become cloudy so keep the filtration pump running continuously until it clears.
- After treatment check the pH level and if necessary adjust.
Dosing Rates:-
Litres Gallons To Increase By 10mg/l To Increase By 20mg/l To Increase By 50mg/l
4,545 1,000 68g 136g 340g
11,364 2,500 170g 340g 850g
22,730 5,000 340g 680g 1.70kg
45,455 10,000 680g 1.36kg 3.4kg
- Additional Information
-
Additional Information
Corrosive Substance No - Reviews
-