Winterisation of Pool Guide
Preparing The Pool For Winter
At the end of the outdoor swimming season, some simple procedures can ensure pool equipment protection is maximised and the water stays in reasonable condition, making it easier to open next spring.
Some of the things that need to be done prior to winterising include:
- Remove solar cover. Clean it and pack it away carefully before storing it away.
- In soft water areas especially, re-check and balance of the calcium hardness level to maintain 2000ppm zone will ensure the pool structure is fully protected.
- Check the pH leve and raise to 7.6 - 7.8, slightly higher than normal levels
Winterising Your Pool (Procedure)
For pools fitted with a main drain
- Lower the water level in the pool to approx. 150 - 200mm below the skimmer mouth opening. Then close the valve for the skimmer(s) on the plant room filter to avoid air suction via the skimmer and so water is drawn from the main drain only. Add your winterising chemicals whilst the circulation is still running for product distribution.
For pool fitted without a main drain
- Add your winterising chemicals prior to draining down but whilst the circulation is running for product distribution. Then lower the water level in the pool to approximately 150 -200mm below the skimmer mouth opening on the pool.
Chemical Treatments
Shock Treatment
Before adding your winteriser, shock treat the pool to ensure all organic pollution, which in turns is food for algae, is removed to give your winter algaecide the best possible start. Keep your circulation system on for chemical distribution,
Shocking with Purisan Shock Chlorine Granules (Calcium Hypochlorite)
| Gallons | Litres | Shock Dose Rate for 10ppm |
|---|---|---|
| 1,000 | 4,454 | 70g |
| 5,000 | 22,725 | 350g |
| 15,000 | 68,175 | 1.05kg |
Shocking with Purisan 14/15% Liquid Chlorine (Sodium Hypochlorite)
| Gallons | Litres | Shock Dose Rate for 10ppm |
|---|---|---|
| 1,000 | 4,454 | 350ml |
| 5,000 | 22,725 | 1650ml |
| 15,000 | 68,175 | 4850ml |
Winterising With Long Life Algaecide
Lo-Chlor Winteriser (5ltrs)
Non Copper based algaecide with sequestrant, for control of most types of algae, together with the prevention of staining and scale formation. Wide produce compatibility including chlorine, bromine and salt treated pools. Tolerant to pH range flocculation.
| Gallons | Litres | Shock Dose |
|---|---|---|
| 1,000 | 4,454 | 420ml |
| 5,000 | 22,725 | 2100ml |
| 15,000 | 68,175 | 6300ml |
Kleenpool Longlife Algaecide (1ltr)
Leading brand copper algaecide for the control of algae. Does not contain sequestrants and can be pH sensitive. Avoid using copper/silver devices or any biguanide treaded pools.
| Gallons | Litres | Prevention Dose | Top Up Dose |
|---|---|---|---|
| 1,000 | 4,454 | 230ml | 75ml |
| 5,000 | 22,725 | 1140ml | 380ml |
| 15,000 | 68,175 | 3400ml | 1140ml |
After Adding your Winteriser (Avoiding Frost Damage)
- Place bungs/stoppers into the water outlets to prevent rainwater entering the pipes
- In the plant room, open the valve for the skimmer(s) and run the pump briefly for a few seconds only to clear the skimmer pipelines of water.
- Turn the filtration system off.
- Drain down the pump, filter and heater as per the manufacturers instructions.
- Disconnect the pipe work from the pump. If your plant room is subject to freezing or condensation/damp conditions, then remove the pump to a warm dry place.