Hello Guest

Clarifiers and Specialty Guide

In addition to the pool balancing and sanitising, there are a few other tasks that periodically need doing and these fall broadly under two headings, Clarifying and Speciality.

Clarifying

Pool water can become cloudy for a number of reasons:

  • Incorrect water balance
  • Poor or insufficient filtration
  • The start or end of an algae infestation
  • A build-up of bather wastes

 

Within the Tennants Pool Care range there is a selection of clarifiers that will quickly restore water sparkle, but before using them you should ensure that:

  • The water is correctly balanced – see our Guide - Balancing Your Pool Water Guide.
  • The filtration is running for a minimum of 8-hours per days (24-hours for best results) and that the filter does not require backwashing or chemically cleaning.
  • The sanitiser level is being maintained within the ideal range. Once you are satisfied that the above conditions have been met then the Tennants Pool Care clarifiers can help speed up the clarifying process.

 

Blue Horizons Aquasparkle Tabs

These easy to use tablets are dosed via the skimmer and should only be used in pools with sand filtration systems. When Blue Horizons Aquasparkle Tabs are added to the skimmer they dissolve fairly rapidly and move into the filter where they put a layer of coagulant on top of the sand. This layer of coagulant traps small particles, stopping them from passing through the filter and back into the pool. This action of removing small particles helps create truly sparkling water. The coagulant is removed when the filter is backwashed, so for continued small particle entrapment repeat dose after backwashing. Each tablet treats 40,000 litres (9,000 gallons).

Jolly Gel & Miraclear Cubes

Jolly Gel & Miraclear Cubes improve filtration efficiency by coagulating debris and 'tightening' the filter bed. Easy and safe to use in a pool pump basket, each gel block treats from 12,000 gallons to 30,000 gallons depending on version purchased.

Lo-Chlor Ultra Kleer 4 in 1

Lo-Chlor Ultra Kleen 4 in 1 is a superb water clarifier. It is manufactured using Chitosan which is produced from the exoskeletons of crustaceans (crabs, lobster and prawns etc). It is a natural polymer and 100% biodegradable. In addition to enhancing filtration it also removes dissolved metals and oils. 500mls treat a 60,000 pool (dose full 1ltr bottle on newly filled pools).

Lo-Chlor Maxi Floc Plus

Lo-Chlor Maxi Floc Plus is a heavy duty flocculent with a built-in accelerating agent for maximum efficiency. The cloudiest pool will clear in 6 hours. This product leaves no messy residue and will aid the removal of phosphates from pool water. 1ltr will treat 50,000 litres (11,000 gallons) pool water. Isolate filter prior to dosing and follow instructions on the pack.

Purisan Aluminium Sulphate 17% Kibbled Alum

Purisan Aluminium sulphate 17% iron free kibble Alum is used as a coagulant for pools equipped with sand filter only, it is dosed directly to the pool.

Speciality Products

Blue Horizons Chlorine Reducer

Blue Horizons Chlorine Reducer is used to lower Bromine or chlorine levels in pool water after shock treatment procedures or as a problem solver if the pool has been accidentally 'overdosed' with chlorine or bromine. Dosing Rates -

Pool VolumeChlorine Reducer to Lower by 5mg/l
Litres Gallons 1mg/l 5mg/l
4,545 1,000 23g 114g
22,500 5,000 114g 568g
45,450 10,000 227g 1140g

 

Lo-Chlor Starver X Phosphate Remover

Lo-Chlor Starver X Phosphate Remover liquid based product which removes phosphates (algae nutrient) from your swimming pool water. This in turn means that algae growth will be greatly reduced and less cleaning and vacuuming will be required to maintain crystal clear algae free water (not suitable for cartridge filters).

This product should be used on pools with high levels of phosphate, for lower levels under 2ppm use standard Lo-Chlor Phosphate remover. To lower phosphate levels in 11,000 gallons (50,000 litres) pool by 6ppm dose 1000ml Starver X to lower by 1ppm, in the same pool dose 168mls.

Lo-Chlor Starver Phosphate Remover

Lo-Chlor Starver Phospahte Remover removes phosphates which is the major food source for algae in pool water. Starver is most effective when treating phosphate levels below 2ppb. For higher levels use Lo-Chlor Starver X.

Initial Dose - For readings up to 1ppb add starver at a rate of 500mls per 11,000 gallons (55,000 litres) of pool water. For a greater reading than 1ppm but below 2ppb add starver at a rate of 1ltr per 11,000 gallons (50,000 litres) every 2-3 weeks.

Maintenance Dose – For readings between 0 – 0.2ppm a regular maintenance dose of 500mls per 11,000 gallons (50,000 litres) water is required every 2 weeks.

Purisan Chlorine Stabiliser

Rapid Dissolving Purisan Chlorine Stabiliser prevents chlorine loss to sunlight. This is especially useful where an unstabilised chlorine product is being used. Usually added to pool water on first fill, or on emptying and refilling, or when substantial fresh water has been added.

The ideal range should be 0 -60mg/l, if above this figure a partial empty and refill will be necessary.

Dosing Rate -

Pool VolumeChlorine Stabiliser to Increase level by 30mg/l
Litres Gallons 10mg/l 30mg/l
4,545 1,000 45g 135g
22,500 5,000 225g 675g
45,450 10,000 450g 1350g

 

Lo-Chlor Multi Stain Remover

Lo-Chlor Multi Stain Remover is specifically designed to remove stains such as iron, copper, manganese, tannin and cobalt (black staining on fibreglass pools) from swimming pool surfaces. Most stains are the result or incorrectly balanced water. Once stain has been removed use either Lo-Chlor No More Metal or CuLator to prevent recurrence.

Dose at a rate of 1000g per 11,000 gallons (50,000 litres) of pool water.

Lo-Chlor No More Metal

Lo-Chlor No More Metal is a superior metal sequestrant designed to remove dissolved metals from pools, spa and hot tubs. The product is a must for all stain treatments. It can be used to prevent scale build up and is ideal for the initial filling of new pools. Most stains are a result of incorrectly balanced water.

Pools should not be shocked treated within 48 hours of the addition of No More Metal. This product must be used alongside Multi Stain Remover in all stain treatments to ensure released metal ions are sequestered, otherwise repeat staining my occur.

Initial fill of new pool Dosage - mix 50ml in a clean plastic bucket of water and add to the pool for every 1,100 gallons (5,000 litres) of pool water. Repeat procedure as the pool fills.

Standard Dosage - 500mls per 11,000 gallons (50,000 litres) of pool water.

CuLator Metal Eliminator

Most metal removers work by sequestering metal ions in the pool water and then rely on the pools filter to remove them over time. Sequestering agents can break down quite quickly releasing the metals back into the water. CuLator Metal Eliminator is different and unique in that metal ions are captured by the non-hazardous polymer in the CuLator bag and so doesn't rely on the pools filtration system to remove them. Add bag to the skimmer baskets.

Cu-Lator removes copper, iron, manages, cobalt, nickel, silver and lead. Its non-toxic and contains no phosphates. It lowers TDS. Please note as CuLator removes lanthanum in lanthanum based phosphate removers avoid using at the same time, also if using copper based algaecide, remove the Culator bag from the skimmer basket when dosing the algaecide and replace it 3 or 4 days later.

Various strengths are available depending upon requirements.    

Heatsavr Liquid Pool Cover

Heatsavr Liquid Pool cover put a 1 molecule layer which floats on the water surface reducing water evaporation and heat loss.

This site uses cookies. By continuing to browse this site you are agreeing to our use of cookies. Find out more here.
x